Standardized Operation Using Spiral Duct Machine

The normal opening and closing of the spiral duct machine often directly affects its service life, the statistical results show that the opening wear of the spiral duct machine is close to 30 to 50%, especially when opening in winter, due to a period of shutdown, the oil film between the piston and the cylinder wall and the oil flow back to the oil bottom of the lubrication part, and the wear is greatly increased.In this case, it is not immediately to start running, pay attention to preheat the machine in advance before starting, and use the protective effect of oil before the screw duct machine is started, first shake the engine crankshaft with the hand crank, and make the oil reach each friction surface as much as possible; When stopping for a short time, do not directly turn off the engine, let the spiral duct idle for a few minutes.In addition, when the spiral duct machine works in a harsh environment such as high temperature and cold, the spiral duct machine should be effectively protected, and some parameters of the spiral duct machine should be adjusted according to the actual situation, knowing that the machine also depends on reasonable operation and normal maintenance to play a greater role.