Installation Points Of The Spiral Duct Machine

1. The installation and disassembly of the dust collector should be in the correct position and keep it firm and stable. The direction of import and export must meet the design requirements, the allowable deviation of verticality is not more than 2mm per meter, and the total deviation is not more than 10mm.

2. The inlet and outlet of the spiral duct machine and the dust collector should be straight, the discharge pipe of the cylinder and the cone should be coaxial, and the eccentricity should not be greater than 2mm.

3. The allowable deviation between the outer diameter of the spiral duct machine and the outer diameter of the dust removal cylinder or the outer diameter of the rectangle is not more than 5%, and the inner and outer surfaces should be smooth and uniform in curvature.

The spiral duct machine is prone to excessive pressure during operation, which is caused by its working principle. Once the pressure of the spiral duct machine is too high, a series of failures will occur. We professionally refer to these failures as pressure overload phenomena for spiral duct machines. In the production process of some factories, it is necessary to transport loose particles, especially those with a small specific gravity, such as foamed plastic particles. The spiral air duct made of low cost and good effect. The overload maintenance system has undergone multiple generations of replacement. Old-fashioned overload maintenance devices in machinery, such as the collapsed block type, etc., cannot accurately transmit information and effectively maintain the machine tool, and are very laborious to replace, so they are being phased out gradually. It was replaced by an overloaded maintenance system for quick unloading and quick recovery.